Disk on Module DOM SATA D150 Vertical Built-in Power (pin7)
This DOM model has the built-in power input directly on the SATA port. It means you don't need to connect the SATA DOM to an external power source ( on the motherboard or power supply ). However please verify if your motherboard has the power capacity on SATA port ( on pin7 ) otherwise this unit will not work and on this case, we suggest the same model without the Built-in Power function.
The SATA DOM D150S product line is the latest generation of SATA Disk on Module. Connected directly to the motherboard. It supports SATA II Standard (3.0Gb/s) interface with excellent and fast data transfer rate; in sustain read 25MB/s (max.) and sustain write 15MB/s (max.). Moreover, Innodisk SATADOM is the smallest form factor in the world that enhances functionality with various design applications.
Zero Mechanical Interference
Anti-Vibration Connector Design
Build-in Power Pin Design
Intelligent Wear Leveling
Auto ECC Function
Please check all the various models on the page below.
Commercial Temperature Operating Range: 0c to +70c
Flash memory can be erased a limited number of times. This number is called the
erase cycle limit or write endurance limit and is defined by the flash array
vendor. The erase cycle limit applies to each individual erase block in the
flash device SATADOM D150SV wide temp uses a wear-leveling algorithm to ensure that consecutive
writes of a specific sector are not written physically to the same page in the
flash. This spreads flash media usage evenly across all pages, thereby
maximizing flash lifetime.