Industrial Storage // memorydepot.com

2GB 2.5 ATA 6000 Solid State Flash Disk IDE 44 pin D2DC-02GD11C

IDE Solid State Flash Disk
2GB

Industrial Laptop Size 2.5 44pin IDE PATA Solid State disk. Extremly reliable based on Industrial Chips for Industrial / Embedded Applications
Commercial Temp

The ATA6000 Solid State Disk is the next generation of storage device based on industrial flash memory technology, which emulates an ordinary magnetic hard disk.

Built for speed, these Solid State Storage Devices need no moving or spinning parts, and that makes no mechanical noise, suitable for used in portable or embedded system, which has only limited power consumption. The Flash Disk Drive products are also free from extra and special algorithm or some firmware driver. Just plug the unit into the IDE 44pin slots and operate it as same as a regular Hard Disk Drives.

These high-speed SSD units provide faster and higher performance storage solution for industrial application, embedded computing, high-speed networking, broadband communications, mobile computing, military, medical and aerospace

In Addition of high-performance, the devices are capable of withstanding a higher dree of enivornmental distress, delivering extreme endurance.

Model variation
ATA 6000 - Commercial Temp -10 +70
ATA 6000 - Wide Temp -40 +80


PRICING AND PRODUCT DETAILS

Flash in Disk (FiD) 2.5 ATA6000 products provide high capacity 2.5-inch solid-state flash disk that electrically complies with ATA6 standard. InnoDisk FiD 2.5 ATA6000 is 2.5-inch solid-state data storage systems under industrial environment. FiD 2.5 ATA6000 supports PIO (0-4), Multiword DMA(0-2) and Ultra DMA(0-5) transfer modes. FiD 2.5 ATA6000 supports LBA addressing mode.

General Specifications

Burst Transfer Rate : 100MB/sec (UDMA5)
Sustained Read : 60MB/sec
Sustained Write : 40MB/sec
Average Latency : 0.4 ms
DC Input Voltage: +3.3V/+5V Single power supply
Dimension: 100.1/69.8/9.5 mm (W/T/H)
Compatibility: CE  and FCC standards
Boot

No additional device drivers are required. Flash in Disk (FiD) 2.5 ATA6000 can be configured as a boot device.


Wear Leveling

Flash memory can be erased a limited number of times. This number is called the erase cycle limit or write endurance limit and is defined by the flash array vendor. The erase
cycle limit applies to each individual erase block in the flash device. FiD 2.5 ATA6000 uses a wear-leveling algorithm to ensure that consecutive writes of a specific sector are not written physically to the same page in the flash. This averages flash media usage evenly across all pages, thereby flash lifetime extends.


Environmental Specifications

Operating Temperature Range
Standard Grade: -100C ~ +700C
Industrial Grade: -400C ~ +850C
Storage Temperature Range
Standard Grade: -550C to +950C
Industrial Grade: -550C to +950C
Reliabily and Durability
Reliability Test Conditions
Vibration: 7 Hz to 700Hz, 2 g, 3 axes
Mechanical Shock Duration: 0.5ms,1 500 g, 3 axes
Product Condition MTBF (Hours): FiD 2.5 ATA6000 Telcordia SR-332 GB, 25 0CC > 3,000,000



Manual CHS Value
Capacity Cylinders Heads Sectors LBA
8GB 15731 16 63 15856848
16GB 16383 16 63 31717632
32GB 16383 16 63 63438848
64GB 16383 16 63 126877696
128GB 16383 16 63 253755392



SATA DOM Vertical Disk on Module